Publicité
Les langues disponibles
Les langues disponibles
4.
Disconnect the flexible gas supply
line from the dryer. Put a piece of tape
over the open ends of the gas line
connection fittings,
5. Pull the dryer away from wall so that
it can be tipped on its back,
6. Protect the floor with a large piece of
cardboard cut from the pedestal carton.
Lay the dryer on its back (make sure
that the power supply cord is not under
the dryer) so that the cardboard is
under the entire lower back edge of the
dryer (see Figure 1 ). Go to "Installing
the Pedestal".
if yourwasheror dryeris
still in its packaging:
Excessive Weight Hazard
Use two or more people to move
and install washer or dryer.
Failure to do so can result in back
or other injury.
1. Position the packaged washer/dryer
close to its final position. Cut the
packaging as follows:
Washer: Cut plastic film along dotted
cut line around the base. Do not
remove the packaging.
Dryer: Cut carton around top and down
corners along dotted cut lines. Lay all
four carton sides on floor. Discard
carton top and corner posts. Important:
Leave carton bottom underneath dryer.
dryer
shown
carton
sides
2o Lay washer/dryer on its back.
NOTE: When laying the washer on its
back, hold the bottom cap down on the
floor. Do not remove the plastic film,
corner posts or top cap. These protect
the floor and washer back.
When laying the dryer on its back, the
floor and dryer back are protected by
cartoning.
Go to "Installing the pedestal".
Installing the
pedestal
Follow these instructions to install the
3edestal on a washer or dryer.
Excessive Weight Hazard
Use two or more people to move
and install pedestal.
Failure to do so can result in back
or other injury.
t
[] Open pedestal drawer and
remove envelope taped inside. This
envelope contains four spacer pads
used in this step and four #12 x 5/8"
(1.6 cm) hex head sheet metal screws
used in Step 4.
* Remove the four spacer pads and
snap them into the holes in the top of
the pedestal.
* Remove the two yellow pads from the
front of pedestal and discard.
pacer pads
\
yellow
pads
_ Remove the Phillips head screw
from both drawer slides and save
screws. Remove the drawer from the
slides and set aside. Push the slides
back into the pedestal.
_ If your washer/dryer has feet
installed, remove them. Do not install
the feet that came with a new
washer/dryer.
_ Partially install the two
#12 x 5/8" (1.6 cm) hex head sheet
metal screws in the lower holes. Leave
a space of about 3/8" (1 cm) between
the screw head and the bottom of the
washer/dryer.
washer bottom
dryer bottom
install screws
x/
install screws
[] Move the pedestal against the
washer/dryer
bottom. Slide the
pedestal's keyhole slots over the lower
two partially installed screws.
Position the pedestal toward the front of
the washer/dryer
and install the two
remaining hex head sheet metal
screws. Do not tighten completely.
Align the sides of the pedestal so that
they are even with the sides of the
washer/dryer. Reach inside pedestal
drawer opening and securely tighten all
four pedestal screws.
dryer
[] Tip the washer/dryer back to its
upright position. Remove and discard
packaging including washer's plastic
film, corner posts and top cap.
[] Slide the washer/dryer
close to
its final location.
[] Follow the Installation
Instructions that came with your model
to finish installing or reinstalling your
washer/dryer (i.e., hoses, vents, etc.). 3
Publicité
