Publicité
Les langues disponibles
Les langues disponibles
Yoursafety
and the safety of
others are very important.
We have provided many important
safety messages in this manual and
on your appliance. Always read and
obey all safety messages.
This is the safety alert
symbol.
This symbol alerts you to
potential hazards that can kill or hurt
you and others.
All safety messages will follow the
safety alert symbol and either the
word "DANGER" or "WARNING."
These words mean:
You can be killed or seriously
injured if you don't immediately
follow instructions.
You can be killed or seriously
injured if you don't follow
instructions.
All safety messages will tell you
what the potential hazard is, tell you
how to reduce the chance of injury,
and tell you what can happen if the
instructions are not followed.
Explosion
Hazard
Keep flammable
materials
and
vapors, such as gasoline, away from
dryer.
Place dryer at least 18 inches
(46 cm) above the floor for a garage
installation.
Failure to do so can result in death,
explosion, or fire.
NOTE: If dryer and pedestal assembly
is located in a garage, 6" (15.2 cm)
must be added under pedestal so that
dryer is 18" (46 cm) above garage floor.
Toolsrequired:
* Utility
knife
* Phillips
screwdriver
(drawer
removal)
* 1/4" (6.4 mm) hex head ratchet
or
open-end
wrench
(leveling
legs)
Figure 1
* 5/16" (8 mm) hex head
ratchet
(sheet
metal screws)
._____'k, ,,,
* Level
* 9/16" (14.3
mm) open-end
wrench
_k
'_
(leveling
leg Iocknuts)
(3012''r'.vv
m\
* pliers or slip-joint
pliers (for drain and inlet
hoses)
15"
(38.1
Beforeyou start,,,
IMPORTANT:
If your washer and dryer
are already installed, they must be
uninstalled.
If you need to uninstall your washer or
dryer, see Installation Instructions that
came with your model for tools
required.
IJninstalling your washer:
Excessive Weight Hazard
Use two or more people to move
and uninstall
washer.
Failure to do so can result in back
or other injury.
1 .Turn off the hot and cold water
faucets.
2, Unplug the power supply cord.
3, Slowly loosen the fill hoses at the
faucets to relieve the water pressure.
Use a sponge or towel to absorb the
released water.
4.
Remove the "HOT" and "COLD" fill
hoses from the back of the washer.
Drain water in the hoses into a bucket.
5. Squeeze the ears of the drain hose
clamp with pliers to open and slide the
clamp down the hose. Disconnect the
drain hose from the washer and drain
any water in the hose into a bucket.
6, Pull the washer away from wall so it
can be tipped on its back.
7, Protect the floor with a large piece of
cardboard cut from the pedestal carton.
Lay the washer on its back (make sure
that the power supply cord is not under
the washer) so that the cardboard is
under the entire lower back edge of the
washer (see Figure 1). An additional
small amount of water will drain out of
the washer when it is tipped back. Go
to "Installing the Pedestal".
cardboard
Uninstallingyourelectric
dryer:
Excessive Weight Hazard
Use two or more people to move
and uninstall
dryer.
Failure to do so can result in back
or other injury.
1. Unplug the power supply cord.
2. Pull the dryer away from the wall
enough to loosen the vent clamp. Loosen
the clamp and carefully remove the
exhaust vent from the dryer exhaust outlet.
3, Pull the dryer away from wall so that it
can be tipped on its back.
4.
Protect the floor with a large piece of
cardboard cut from the pedestal carton.
Lay the dryer on its back (make sure that
the power supply cord is not under the
dryer) so that the cardboard is under the
entire lower back edge of the dryer (see
Figure 1). Go to "Installing the Pedestal".
gninstallingyourgas dryer:
Excessive Weight Hazard
Use two or more people to move
and uninstall
dryer.
Failure to do so can result in back
or other injury.
1. Unplug the power supply cord.
2. Turn off the gas supply.
3, Pull the dryer away from the wall
enough to loosen the vent clamp.
Loosen the clamp and carefully remove
the exhaust vent from the dryer exhaust
outlet.
Publicité
