Precautions; 1 General; 2 Sales Programme - Hexagon TT80 Mode D'emploi

PRECAUTIONS

To get the best possible performances from the electronic length measuring instruments
TESATRONIC TT80 and TT90, read this instruction manual thoroughly before getting
started.

1 GENERAL

Both TT80 and TT90 are used for accurate measurements with one or two TESA inductive
probes (or TESA compatible probes).
The measurement signals generated by the electronic probes are processed, amplified, and
displayed on the analogue or digital indication. The TT90 version is able to operate in either
of the 3 following modes :
– like a TT80 (TT90 in TT80 mode in this manual);
– using all the functionalities of a TT80, but with a range limited to ±200 µm (TT90);
– using all the functionalities linked to the TESA UPC gauge block comparator (TT90-UPC).

2 SALES PROGRAMME

Order numbers :
TESATRONIC TT80
TESATRONIC TT90
Each TESATRONIC is delivered with the following standard accessories:
– 1 Mains adapter 110 to 240 Vac / 50 to 60 Hz
– 1 Adapter cable EU
– 1 Adapter cable US
– 1 Instruction manual with a declaration of conformity
– 1 Suited case
Optional accessories :
– 1 Hand switch
– 1 Foot switch
– 1 Dummy calibration probe 100 µm
– 1 Dummy calibration probe 190 µm
– 1 Dummy calibration probe 500 µm
– 1 Dummy calibration probe 1000 µm
– 1 Opto-RS cable host computer to TESA PRINTER SPC
– 1 Opto-RS cable, bidirectional for full control over
the host computer
– 1 Opto-USB cable, bidirectional, for full control over
the host computer
04430011
04430012
04761054
04761055
04761056
04768000
04768001
S41078228
S41078230
S41078332
S41078751
04761046
04761049
04761062
3