Christopeit Sport SP2000 Instructions De Montage Et D'utilisation page 19

STEP 7
Installation o buttery arm let and right (9L+9R), hand
grip (21) and arm foam (42).
1. Put the let and right buttery arms (9L/R) into the butter-
y arm support (6) and secure with bolt M10x90 (78), washer
10//20 (67) and nylon nut M10 (64). Insert the locking pins (23)
to secure buttery arm position and cover the nuts (64) with
screw cap (74).
2. Slide the arm oams (42) onto the buttery arms let and
right (9L+9R) (perhaps by help of a little bit soap water) and
tighten hand grips (21) at buttery arms (9L/R) with screws
M8x25 (59), screws M8x16 (58) and curved washer 8//25 (72).
Note: For bench press exercising secure the buttery arms
let and right (9L+9R) with locking pins (23) at buttery arm
support (6) and screw loosely and fold back the handgrip nut
(29). For buttery exercising secure position o buttery arm
support (6) with hand grip nut (29) und take out the locking
pins (23) rom buttery arms (9L+9R).I no use o locking pins
you can storage at main rame (34) as gure A shows.
STEP 8
Installation o cable 1 or buttery (38) with pulleys (19).
Note: The assembling of cables needs a simultaneously
assembling of pulleys. So please insert the cable each time
before you assemble a pulley and don't tighten the screws for
pulleys too much. The pulley should turn easy after assembly.
1. Screw one end of the cable 1 (38) at the holder of the
buttery arm let (9L) with bolt M10x35 (51), washer 10//20
(67) and nylon nut M10 (64).
2. Attach one pulley (19) with cable 1 (38) and pulley
covers (20) into 1st pulley holder (27) and secure with hex bolt
M10x50 (50), washer 10//20 (67) and nylon nut M10 (64).
3. Attach one pulley (19) with cable 1 (38) and pulley covers
(20) into twisted pulley holder (26) and secure with hex bolt
M10x50 (50), washer 10//20 (67) and nylon nut M10 (64).
4. Attach one pulley (19) with cable 1 (38) and pulley
covers (20) into 2nd pulley holder (27) and secure with Hex
bolt M10x50 (50), washer 10//20 (67) and nylon nut M10 (64).
5. Screw the other end of the cable 1 (38) at the holder of the
buttery arm right (9R) with bolt M10x35 (51), washer 10//20
(67) and nylon nut M10 (64).
6. Cover all screw heads of screws (50+51) and nuts (64) with
corresponding screw caps (74).
78
23
29
9R
42
21
72
59
74
51
67
9L
67
64
74
74
19
11
6
67
9L
64
74
27
38
38
20
19
20
64
67
26
GB
34
A
23
72
58
9R
20
19
20
67
50
74