Publicité
Les langues disponibles
Les langues disponibles
Important: To ensure that this equipment
reaches
you
in
protective coatings have been use. Flush
the equipment through with a suitable
solvent before use.
1.
Attach air hose to connector (19).
Recommended hose size 8 mm bore.
The hose must be conductive and
1. Mix coating material to manufacturers
instructions
2. Turn
needle
adjusting
counter-clockwise
shows
3. Turn
pattern
clockwise to fully open
4. Adjust inlet air pressure to give 2.4 bar
(35 psi) at the gun inlet with the gun
triggered. (pressure gauge attachment
shown
under
recommended for this)
5. Test spray. If the finish is too dry reduce
airflow by reducing inlet pressure. If
finish is too wet reduce fluid flow by
turning needle screw (18) clockwise. If
1.
Turn off air supply and relieve pressure
in the airline, or if using QD system,
disconnect from airline.
2.
Empty coating material into a suitable
container and clean the gun and cup,
preferably in a gun wash machine.
3.
IMPORTANT– the cup must not be
cleaned or rubbed with a dry cloth
or paper. It is possible to generate a
static charge, by rubbing, which if
discharged to an earthed object
could create an incendive spark and
cause solvent vapours to ignite.
Only use a dampened cloth or
antistatic
wipes
cleaning is required in a Hazardous
© 2012 Finishing Brands UK Ltd.
All manuals and user guides at all-guides.com
EN
EN
Installation
first
class
condition,
Operation
screw
(18)
until
first
thread
valve
(10)
counter-
Accessories
is
Preventative Maintenance
if
additional
electrical bond from the spraygun to
earth should be checked with an
ohmeter. A resistance of less than
6
10
Ω is recommended.
2.
Air supply should be filtered and
regulated.
atomisation is too coarse, increase inlet
air pressure. If too fine reduce inlet
pressure.
6. The pattern size can be reduced by
adjusting valve (10)
7. Hold gun perpendicular to surface being
sprayed. Arcing or tilting may result in
uneven coating.
8. The recommended spray distance is
150-200 mm (6"-8").
9. Spray edges first. Overlap each stroke a
minimum of 50%. Move gun at a
constant speed.
10. Always turn off air supply and relieve
pressure when gun is not in use.
area.
4.
Remove air cap (2) and clean. If any of
the holes in the cap are blocked with
coating material only use the Cleaning
Kit KK-4584 (see accessories) which
has the correct tools for this or a
toothpick to clean. Using any other tool
could damage the cap and produce
distorted spray patterns.
5.
Ensure the tip of the nozzle is clean
and free from damage. Build up of
dried paint can distort the spray
pattern.
6.
Lubrication – Trigger stud (24), needle
(16) and air valve spindle (13) should
be oiled each day.
6
Publicité
