Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION REQUIREMENTS
Tools anc Paris
IMPORTANT:
gm
Installer: Leave Installation Instructions with the homeowner.
m
Homeowner: Keep Installation Instructions for future
reference. Save these Installation Instructions for the local
electrical inspector's use.
TOOLS NEEDED:
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
m
Cordless drill
Torx® T27 screwdriver
ga
Drill bits
12" Nut driver
m
Two adjustable
%" and Ye" Open-end wrenches
wrenches
542" Hex key
Phillips screwdriver
Yq" and %e" Socket drivers
Small level
Tape measure
Appliance dolly
Utility knife
PARTS NEEDED:
mw
Six #8 x 3" (7.6 cm) wood screws (longer screws may be needed)
4" x 32" (6 cm x 10 cm x 81 cm) wood board(s)
m
Overlay Series: Make custom panels, or consult a qualified
cabinetmaker or carpenter to make the panels. See "Overlay
Series Custom Panels" for more information.
mw
Oneor two 2" x
Pro-Style® and Euro-Style Series are shipped complete.
m_
If you are connecting the water line directly to copper tubing
and not to a shutoff valve, you need a ferrule, a union, anda
Ya" (6.35 mm) compression fitting.
T®TORX is a registered trademark of Saturn Fasteners, Inc.
6
Pty, gs,
y
2 Wy,
Location Requirements
The refrigerator can be recessed in an opening between cabinets
or installed at the end of a cabinet run using a side panel to
enclose the refrigerator.
AWARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion, or fire.
IMPORTANT:
m
Observe all governing codes and ordinances.
gm
It is recommended that you do not install the refrigerator near
an oven, radiator, or other heat source.
g
Do not install in a location where the temperature will fall
below 55°F (13°C).
m
Floor must support the refrigerator weight, more than 600 Ibs
(272 kg), door panels and contents of the refrigerator.
m
Ceiling height must allow for side tipping radius. See "Tipping
Radius."
mg
Location should permit door to open fully. See "Door Swing
Dimensions."
mg
Location must permit top grille removal. See "Opening
Dimensions."
Opening Dimensions
gm
To avoid tipping during use, the solid soffit must be within 1"
(2.5 cm) maximum above the refrigerator. If the solid soffit is
higher than 1" (2.5 cm) or one is not available, then the
refrigerator must be braced.
If the anti-tip boards are needed, they must be attached to the
rear wall studs 80" to 90" (203 cm to 229 cm) above the floor.
See "Install Anti-Tip Boards" for more information.
NOTE: A clearance of '%" (1.3 cm) must be maintained above
the top grille in order for the top grille to be removed.
m
Agrounded 3 prong electrical outlet should be located within
a specified number of inches from the right-hand side
cabinets or end panel. See the chart following the graphic for
the number of inches required for your model. For more
information, see "Electrical Requirements."
Publicité
