Publicité
Les langues disponibles
Les langues disponibles
8.
Make final recheck to make sure the doors are aligned and
even.
Door Swing Adjustment
1.
Check that the refrigerator door can open freely. If the door
opens too wide, remove the door stop screw or screws
(depending on your model) from the bottom hinge. See "Door
Height Adjustment" earlier in this section.
Hold the door open to a position that is less than 90°.
3.
Replace the door stop screw or screws in the bottom hinge
and tighten.
A. 130°
B. 110° (Overlay series)
C. 90°
Door-to-Door or Door-to-Refrigerator Trim Adjustment
1.
Loosen, but do not remove, the four Torx®' 27 flat-head
mounting screws and the two 1%" hex-head mounting screws.
2.
Adjust the top hinge of either door to align it with the other
door or the refrigerator trim.
3.
Tighten the four Torx® 27 flat-head mounting screws to a
torque of approximately 100 inch-pounds (11.3 Nm) and
tighten the two 14" hex-head mounting screws.
A. Torx® 27 flat-head mounting screws
B. 14" hex-head mounting screws
22
ge
If the built-in area lamin is _
635 om) 0 or more, the side panels
can be installed inside the side trim or attached to the outside of
the side trim.
IMPORTANT: Jenn-Air is not responsible for the removal or
addition of molding or decorative panels that would not allow
access to the refrigerator for service.
1.
For the inside side trim piece, slide the front edge of the
routed side panel into the trim piece.
T®TORX is a registered trademark of Saturn Fasteners, Inc.
22
2.
Nail the rear edge of the panel to the support board.
A. Support board (mounted to back wall)
B. Cab side trim
install Be
There are two pieces to the base grille to allow for a custom fit: the
base grille itself and the skirt. The skirt can be added to the base
grille in order to extend it all the way to the floor.
1.
To see whether the skirt is needed, place the base grille into
position. Do not attach the base grille to the refrigerator.
Measure the distance between the bottom of the base grille
and the floor. The gap must be a minimum of %" (1.27 cm) in
order to add the skirt.
NOTE: If the gap measures less than 12" (1.27 cm), skip
steps 3 and 4
of the instructions, and install the base grille
e Grille
ae
ag
BD at
fe
Cs
only.
2.
Remove the film from the base grille.
3.
Snap the skirt onto the base grille.
A. Base grille
B. Skirt
Publicité
