Publicité
Les langues disponibles
Les langues disponibles
2.
Push the top grille straight up; then pull straight out. Lay the
grille on a soft surface.
A. Top grille
B. Cabinet side trim
3.
Remove the six screws attaching each cabinet side trim to the
refrigerator and remove the side trims.
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.
1.
Place an appliance dolly under the left side of the refrigerator
as shown. Place the corner posts from the packing materials
over the trims and handles as appropriate to avoid damage.
Slowly tighten the strap.
NOTE: Pass the dolly strap under the handles for the
Architect® Series.
Place pieces of the shipping carton on the floor when rolling
the dolly and refrigerator into the house. Move the refrigerator
close to the built-in opening.
Place top of cardboard carton or plywood under refrigerator.
Stand the refrigerator up. First, place the left bottom edge of
the refrigerator on the floor, stand the refrigerator upright and
then lower the right-hand side of the refrigerator to the floor.
Reassemble the trim and top grille after the dolly has been
removed from the refrigerator.
Laon endegouh
By om 8 %
install Ant
IMPORTANT:
To avoid tipping during use, the solid soffit must be within
1" (2.5 cm) maximum above the refrigerator. If the solid soffit is
higher than 1" (2.5 cm) or one is not available, then the
refrigerator must be braced.
It is recommended that board(s) be installed before the
refrigerator is installed.
Board(s) must be long enough to fully cover the width of the
compressor cover.
Locate the board(s) so the bottom surface(s) of the board(s)
is(are) 84" (213 cm) from the floor.
During installation, raise the refrigerator up so there is
Ya" (6.35 mm) maximum
between the top of the refrigerator
and the bottom of the anti-tip board(s). Do not crush the
compressor cover when raising the rear leveling legs.
To Install Anti-tip Boards
1.
2.
Mark the stud locations on rear wall 80" to 90" (203 cm to
229 cm) above floor.
Securely attach one or two 2" x 4" x 32" (6 cm x 10 cm x
81 cm) boards to wall studs behind refrigerator. Use six
#8 x 3" (7.6 cm) (or longer) wood screws. The wood screws
must be screwed into the studs at least 14" (3.8 cm). The
board(s) must overlap the compressor cover.
A. Center board 14" (6.35 mm) max. above refrigerator
B. Two 2" x 4" x 32" 6 cm x 10 cm x 81 cm) boards
C. Attach to studs with six #8 x 3" (7.6 cm) screws
D. Compressor cover
17
Publicité
