Klipsch HD THEATER SB 3 Manuel Du Propriétaire page 3

PACKING LIST
1. SOUNDBAR
2. WIRELESS SUBWOOFER
3. SOUNDBAR POWER SUPPLY/POWER CORD
4. SUBWOOFER POWER CORD
5. 4.9 FOOT (1.5M) DIGITAL OPTICAL CABLE
6. DUAL RCA CABLE
7. TWO CRADLES
8. ONE REMOTE CONTROL
9. QUICK SETUP GUIDE
10. SOUNDBAR WALL-MOUNT TEMPLATE SUBWOOFER
VOLUME
11. THIS OWNER'S MANUAL
MIN MAX
SOUNDBAR FRONT
SOURCE MUTE
SOUNDBAR STATUS LIGHT
(Right status light, unless stated)
RED: In STANDBY ("Sleep") Mode
POWER
GREEN: On Digital Optical Cable Input
AC~100-240V
ON OFF
ORANGE: On Analog RCA L/R Input 50/60Hz
90W
ORANGE (Flashing): RCA Input muted
GREEN (Flashing): Digital Input muted
RED (Flashing): Failure to learn a remote
control command
SOUNDBAR REAR
Analog RCA Inputs
1 SOURCE
R
L
Digital Optical
Cable Input
SOUNDBAR RIGHT SIDE
3.5mm Analog Input
All manuals and user guides at all-guides.com
STATUS LIGHTS
VOLUME DOWN VOLUME UP
GREEN OR ORANGE FLASHES: A remote
control signal has been received
BLUE:
On 3.5 mm Analog Input
RED and GREEN (Alternating):
Remote Programming
WHITE (Left Status Light):
In 3D Surround Mode
Power Supply Input
2
DC IN
POWER
24V – 2.5A
60W
OFF
Main Power
SUBWOOFER REAR
SUBWOOFER
VOLUME
MIN MAX
POWER
AC~100-240V
ON OFF
50/60Hz
SUBWOOFER STATUS LIGHT
BLUE (Solid): Receiving wireless signal from soundbar
RED (Solid): Searching for soundbar wireless signal
R
PLACEMENT/INSTALLATION
L
1. Placing/wall-mounting the soundbar: The soundbar is designed to be placed on a
flat surface directly in front of your TV on its two supplied cradles, on a shelf direct-
ly above or below your TV in a piece of furniture or wall-mounted (via keyholes on
the rear of the soundbar) under a TV that is also wall-mounted. If wall-mounting,
first, use the supplied wall-mount template to mount soundbar. If the two mounting
holes drill into wall studs, screw two wood screws in those holes to hang the sound-
bar on. If there are no wall studs where the holes are drilled, use wall anchors that
support at least 7 pounds (3kg) each to hang the soundbar on. Connect cable from
TV (see Connection section) to soundbar and hang soundbar on wall.
ON
2. Placing the subwoofer: The subwoofer is designed to be placed on the floor in the
same room within 50 feet (15m) of the soundbar near an electrical outlet. For
maximum bass output, place the subwoofer in a corner on the same wall as the TV
and soundbar. Once the soundbar has been connected to the TV and plugged into a
wall outlet, plug the subwoofer into a wall outlet.
90W
1 SOURCE 2
DC IN
POWER
24V – 2.5A
60W
OFF
TV
Volume Control
Status Light
Main Power ON/OFF
Power Cord Input
ON
TV