Aqua Medic BLENNY Qube Manuel D'instructions page 5

1. Product description
Following parts are included:
- Aquarium 40 x 50 (incl. filter chamber) x 40 cm
- Skimmer EVO 500
- Current pump EcoDrift 4.1
- Illumination Qube
- Filter separating wall
- Filter basket for taking up activated carbon or phosphate absorbers
A timer and a socket board are not included.
2. Set-Up of the aquarium
The aquarium can be placed directly on a sufficiently solid cabinet or desk. Beforehand, the cabinet
plate and the lower surface of the aquarium should be cleaned to prevent the bottom pane of glass
from bursting through grains of sand or any dust particles.
First of all, the aquarium has to be cleaned with clear water. Afterwards, the protective plastic film
has to be pulled off the black plastic rear wall (if applicable).
The lower edge of the rear wall has a lip made of self-adhesive foam rubber. Wipe any fingerprints
off the lower edge by using a dry cloth. Remove the protective plastic film from the self-adhesive
strip, apply and remove any excess rubber.
Now, push the rear wall into place.
3. Current pump EcoDrift 4.1
See attached manual.
The pump is open at the front. Therefore, it should never be started uncontrolled. Animals
could be found in the sucking in basket and they could be injured or killed by the starting propeller.
The pump has to be adjusted in such a way that the water level in the filter chamber is not greatly
reduced or fluctuates. Otherwise, the skimming process is not working.
There is an opening at the rear wall for inserting the current pump. First, insert the rubber O-ring
into the hole of the filter chamber (not from the aquarium side). Now, the pump has to be pushed
into the retaining O-ring.
4. Skimmer EVO 500
See attached manual.
The skimmer is hung on the middle separating wall of the filter chamber without holder. The pump
basket has to be removed.
upwards.
5. Illumination
LED Illumination Qube (see separate manual).
Available spare parts: Please refer to www.aqua-medic.de.
All manuals and user guides at all-guides.com
The pump must be mounted the way that the suction side points
5