Amana 7200 Serie Instructions D'installation page 7

ELECTRICAL REQUIREMENTS
NOTE: Wiring diagram is located below the Top Cover.
Export models (not U.S. or Canada): See Additional Instructions for Export Models on the other side of this sheet.
•
Improper connection of the equipment grounding conductor can result in a risk of electric
!
WARNING
shock. Check with a qualified electrician or serviceman if you are in doubt as to whether
the appliance is properly grounded. Do not modify the plug provided with the appliance – if
it will not fit the outlet, have a proper outlet installed by a qualified electrician.
• To prevent unnecessary risk of fire, electrical shock or personal injury, all wiring
and grounding must be done in accordance with local codes, or in the absence of local
codes, with the National Electrical Code, ANSI/ NFPA No. 70-Latest Revision (for the US)
or the Canadian Electrical Code CSA C22.1 - Latest Revisions and local codes and ordinances. It is the
personal responsibility and obligation of the appliance owner to provide adequate electrical services for
this appliance
• All gas installations must be done in accordance with the national Fuel Code ANSI/Z2231 - Last revision
(for United States) or CAN/CGA - B149 Installation Codes - Latest Revision (for Canada) and local codes
and ordinances.
GROUNDING
This dryer must be grounded. In the event of malfunction or breakdown, the ground will reduce the
risk of electrical shock by providing a path of least resistance for electrical current.
GAS MODELS
This appliance is equipped with a cord having an equipment-grounding conductor and a grounding
plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
Do not modify the plug provided with the appliance – if it will not fit the outlet, have a proper outlet
installed by a qualified electrician.
f a separate ground is required by local codes, a grounding kit (Part No. 12001875) is available. It
I
contains ground wire, clamp, ground screw and washer. Connect ground wire to back of unit with the
cabinet ground screw and washer. Secure other end of ground wire to a suitable external ground
connection. The wire may be secured with the clamp to a grounded COLD metal water pipe
NEVER CONNECT GROUND WIRE TO PLASTIC PLUMBING LINES, GAS LINES OR HOT WATER
PIPES.
ELECTRIC MODELS
This appliance is equipped with a cord having an equipment-grounding conductor and a grounding plug.
The plug must be plugged into an appropriate outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
If a power cord is not used and the electric dryer is to be permanently wired, the dryer must be
connected to a grounded metal, permanent wiring system; or an equipment grounding conductor must
be run with the circuit conductors and connected to the equipment grounding terminal.
7
Get other manuals https://www.bkmanuals.com
.