Door Lock Switch Duration Setup; System Error; Technical Specifications; Indoor-Unit - Alecto ADI-250 Mode D'emploi

11.4 Door lock switch duration setup:

You may set a time for how long the door lock can be activated.
1. With the indoor unit on stand-by, first briefly press the
indoor unit
2. Now simultaneously press the
hold these buttons for 5 seconds. "Unlock time" will appear in
the display.
3. Use the
with door lock (1~4)
4. Press the
5. Now press the
display as a confirmation.
6. The screen turns off automatically after 5 seconds.
12.

SYSTEM ERROR

If you think that an error has occurred in the system, please remove the batteries
from the indoor unit and outdoor unit. Now wait several minutes and replace the
batteries. If this does not resolve the problem, please contact the Alecto service
department via the internet www.alecto.nl
13.

TECHNICAL SPECIFICATIONS

13.1 Indoor-unit

Receiving Frequency Range:
Monitor:
Data Rate:
Receiving Sensitivity:
Demodulation Type:
Resolution:
Transmitting Power:
Power Requirement:
Power Consumption:
Operating Temperature:
Operating Humidity:
Weight:
Size receiver:
charger:
No. of outdoor stations:
and buttons to select the correct outdoor post
or button to set the switch duration (1~25 sec.)
Back soft-button; "OK" will appear in the
button and the right
2.400GHz ~ 2.4835GHz
3.5'' Color LCD
2.0Mbps
-90dBm
GFSK
320x240(RGB)
19dBm (TYP)
Ni-MH3.6V, 800mAh
400mA Max
-10°C ~ 40°C
0% ~ 85%RH
188g
85x115x27mm (WxHxD)
93x55x75mm (WxHxD)
Max.4
-69-
button to wake up the
button and press and