Alecto ADI-250 Mode D'emploi page 61

• a photo was already taken upon ringing the doorbell, but you may choose to take
another picture of your visitor during your conversation by pressing the
• press the
disconnected automatically)
When multiple outdoor units are registered:
When multiple outdoor units are registered and somebody presses the doorbell,
the camera number X# in the upper part of the screen will indicate at which outdoor
unit your visitor is calling.
6.3 Monitor: (looking outside yourself (only when used on external power))
Also when there's nobody pressing the doorbell, you may still enable the camera
and take a picture.
• briefly press the
• press and hold the
the display will be enabled to show the area in front of the camera
• you may listen via the speaker (talking back is only possible after pressing the
button)
• press the
• press the
disconnected automatically
When multiple outdoor units are registered:
When multiple outdoor units are registered and you press and hold the
ton for 1 second, you must first use the
outdoor unit and then press the
Attention: if the outdoor unit is powered by batteries, the monitor function
is NOT available.
button to disconnect the call (or wait for 2 minutes until the call is
button to switch on the indoor unit from its sleep mode
soft-button for 1 second to switch on the monitor function;
button to take a picture
button to disconnect or wait for 5 minutes until the connection is
and buttons to select the desired
button to confirm.
-61-
button.
but-