Garland FUM KEEPER 20V 310 M Manuel D'instructions page 28

English
6.2.4. SPEEDING REGULATOR ASSEMBLY
6.2.4. FILTER COLOCATION
6.3. BATTERY CHARGE
The supply voltage and current must comply with the
indications on the charger's nameplate.
Before using the battery for the first time, charge it for
at least 1 hour.
To charge the battery, plug the charger into the mains,
the led will light up red. Put the battery in the charger,
the led will turn green and start blinking. The charger
LED will turn from flashing green to green when the
battery is fully charged. When the battery is charged,
remove it from the charger. If you leave the battery
in the charger and it is fully charged, the charger will
automatically turn off after 2 hours, the green LED
still on.
The charging time for a fully discharged battery is 2.5
hours.
If you insert the battery into the charger and the
led starts blinking red, it means that your battery is
damaged or that the battery does not correspond to
this charger.
Recharge the battery when you notice that the power
of your machine decreases. Avoid using the machine
until the battery is fully discharged.
Battery charge indicators
Grades:
- The battery will require 2 or 3 complete charge
discharge cycles to reach its maximum energy storage
capacity.
- This battery does not have a memory effect so it is
not necessary to fully discharge it before recharging it.
- If you are not going to use the battery for a long
period of time, charge it to the maximum, store it in an
appropriate place and recharge it every 30 days.
28/100
Charge button