Qlima MS-AC 5001 Manuel D'utilisation page 91

man_MS-AC 5001 ('23) V3.indd 91
Problem Reasons
No power.
The device does
Damaged electrical outlet.
not turn on.
Unknown reason.
The lowest ventilation setting
is selected.
The air filter is dirty.
The air supply or exhaust of the
indoor unit is blocked.
Little air
displacement or
limited cooling
The air supply or exhaust from the
effect.
outdoor unit is blocked.
The ambient temperature is too
low or high.
Insufficient voltage from the
power supply.
The device runs in ventilation
Air displacement
mode.
only but no
The cooling mode has just turned
cooling effect.
off automatically.
The mounting brackets are not
Abnormal sounds properly installed on the vehicle, or
or vibrations. the device mounting screws are not
sufficiently tightened.
The rubber stopper on the bottom
of the indoor unit is missing, or is
not pressed
Water is leaking
enough.
from the indoor
unit.
The device is at an angle
The appliance
emits a related There is a serious problem.
odor.
If problems not listed in the table occur or recommended solutions do not work, please contact
the service centre.
Solution
Turn power on.
Turn off the power and
check/repair the power outlet.
Contact the dealer.
Select the high ventilation speed
mode.
Check and clean the filter.
Check that the unit is not blocked
and remove the
obstruction.
Check that the unit is not blocked
and remove the
obstruction.
The ambient temperature must
be between 18 and 40ºC.
Consult an installer or use a
different power connection.
Select the cooling mode (A/C).
Wait about 3-5 minutes until
the thermostat switches on again.
Check that the mounting bracket
is tight and tighten the device
mounting screws.
Check or replace the rubber
stopper.
The device must be mounted
horizontally (maximum angle
<3°.)
Switch off the device
immediately and contact the dealer.
4
91
19-07-2023 10:12