Garland SET 352 E Manuel D'instructions page 27

Always disconnect the machine from the mains before
carrying out any maintenance work on the pump. Only
manipulate the machine when the machine has been
unplugged.
2.5. USE AND CARE OF THE MACHINE
Use this machine, accessories and all its parts
according to the instruction manual and taking into
account working conditions and working area. The use
of this machine for jobs different to those specified
in the instruction manual can cause dangerous
situations.
Check that all security elements are in good working
order at all times.
Remember user is the responsible of danger and
accidents caused to other people or things. The
manufacturer will not be liable for damages caused
through the incorrect usage of the machine.
The sharp cutting tool is very dangerous. If
instructions are not followed it will result in serious
injury.
Keep all parts of your body away from the cutting tool
during operation
Do not overload the machine. Use the machine for its
correct usage. If used correctly the machine will do
the desired job.
Do not use this machine if the ¨open¨ and ¨closed¨
switch does not work. Any electric machine that
cannot be controlled by the electric switch is
dangerous and must be repaired.
Look after the machine. Check that all moving parts
are well aligned and that they are not blocked, that
there are no broken pieces or other conditions that
could affect the proper functioning of the machine.
If this machine is damaged, always repair it before
using it again. Most accidents occur because of poor
maintenance.
If the blades hit a strange element whilst in use, stop
the machine, disconnect the machine from the mains
and examine the machine before restarting work. If
you detect any strange sign, take your machine to
your nearest after sales service.
Maintain the cutting elements sharp and clean. The
cutting elements if sharp and clean will cut better, do
a better job, have less chance of getting tangled and
easier to control.
Maintain the handles of the machine dry and clean.
Handles that are not clean and dry cause these to
be slippery and a consequent loss of control over the
machine.
If your machine accidentally takes a knock, inspect the
machine carefully. If the blade bends, the cover break
so if you see any other issue that could affect the
functioning of the machine, take the machine to your
nearest after sales service.
Switch off and unplug the machine, and make sure
the cutting tool is stopped before carrying out any
adjustments to any part of the machine, cleaning,
transport or storage the machine. Such security
measures reduce the risk of accidental start up.
Unplug the machine before carrying out any
maintenance work, change of accessories or before
storing the machine. All these measures ensure that
the machine will not be accidentally started.
If the machine starts vibrating in a strange way,
disconnect the machine and examine it. If you cannot
detect why the machine vibrates, take the machine to
27/124
English