Fading In Or Out - Sony CDP-XA20ES Mode D'emploi

4
When you record on both sides of the tape, press
EDIT/TIME FADE again.
The player inserts a pause, then creates the
program for side B. The display shows the
programmed tracks.
When you record on one side of the tape or on a
DAT or MD, skip this step.
5
Start recording on the deck and then press 9 on
the player.
When you record on both sides of the tape, the
player pauses at the end of the program for side A.
6
When you record on side B, reverse the tape and
press 9 or y on the player to resume playing.
To cancel Time Edit/Just Edit
Press PLAY MODE repeatedly until "SHUFFLE" and
"PROGRAM" disappear from the display (or press
CONTINUE on the remote).
You can program the tracks you want in advance
Select the tracks before doing the above procedure. The
player creates a program from the remaining tracks. In
this case, you cannot select "HALF" to specify the tape
length.
You can freely specify the tape length
Set the tape length using « AMS ¯ .
Example: When the tape length of one side is 30 minutes
and 15 seconds
1 To set the minutes, turn
until "30" appears in the display, then push
« ¯ .
AMS
2 To set the seconds, turn « AMS ¯
until "15" appears in the display, then push
« ¯ .
AMS
When tracks, which aren't numerically consecutive on
the disc, are programmed consecutively (i.e. 1, 3, 5
etc.)
A one-second access time blank is added between the
tracks.
You can automatically insert a blank space of 3
seconds between each track
Use the Auto Space function (see page 16).
You can check and change the program
See pages 12 and 13.

Fading In or Out

You can manually fade in or out to prevent tracks from
starting or ending abruptly.
Note that you cannot use this effect when you use the
DIGITAL OUT connector.
To
Start play fading in
End play fading out
Changing the fading time
You can change the fading time from 2 to 10 seconds
before fading in or out. If you don't change it, fading
« AMS ¯
lasts for 5 seconds.
1
Press FADER before you start playing.
"5 SEC" appears and "
display.
2
Press G or @ to specify the fading time.
Fading out at the specified time
(Time Fade)
You can have the player fade out automatically by
specifying the playing time. Once you set the Time
Fade, it works twice, that is, the play fades out at the
end of both sides of a tape.
1
Press EDIT/TIME FADE repeatedly before you
start playing until "
indication appear in the display.
Recording From CDs
Recording From CDs
G / @
FADER
9 y
EDIT/TIME FADE
Press FADER
During pause. lights up in
FADE
the display and the € indication
flashes. The play fades in.
When you want to start fading out.
FADE lights up in the display and
the p indication flashes. The play
fades out and the player pauses.
" flashes in the
FADE
TIME A
" and "A" in the
FADE
(Continued)
EN
15