Troubleshooting; Specifications - Sony CDP-XA20ES Mode D'emploi

Additional Information

Troubleshooting

If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There's no sound.
FCheck that the player is connected securely.
FMake sure you operate the amplifier correctly.
FAdjust the playback level using the LINE OUT/
PHONE LEVEL control (except for UK model).
The CD does not play.
FThere's no CD inside the player. Insert a CD.
FUse the stabilizer.
FPlace the CD with the label side up on the disc
tray correctly.
FClean the CD (see page 17).
FMoisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 17).
The recording level has changed.
FWhen you connect the amplifier via the
VARIABLE LINE OUT jacks, the recording level
changes if you adjust the LINE OUT/PHONE
LEVEL control on the player or press LINE
OUT LEVEL on the remote during recording
(except for UK model).
The remote does not function.
FRemove the obstacles in the path of the remote
and the player.
FPoint the remote at the remote sensor f on the
player.
FReplace all the batteries in the remote with new
ones if they are weak.
EN
18

Specifications

Compact disc player
Laser Semiconductor laser (λ = 780 nm)
Emission duration: continuous
Max 44.6 µW*
Laser output
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequency response
2 Hz to 20 kHz ±0.3 dB
Dynamic range More than 100 dB
Harmonic distortion Less than 0.0023 %
Outputs
Jack Maximum
type output
level
LINE OUT
Phono
2 V
(FIXED) jacks
(at 50 kilohms)
LINE OUT Phono
2 V
(VARIABLE) jacks
(at 50 kilohms)
(except for UK
model)
DIGITAL Optical
–18 dBm
OUT output
(OPTICAL)
connector
DIGITAL Coaxial
0.5 Vp-p
OUT output
(75 ohms)
(COAXIAL) connector
(European and UK
models only)
PHONES Stereo
28 mW
(except for UK phone
model)
jack
General
Power requirements
Where purchased Power requirements
USA/Canada 120 V AC, 60 Hz
Europe/UK
220 V – 230 V AC, 50/60 Hz
Other countries 110 V – 120 V or 220 V – 240 V AC,
adjustable, 50/60 Hz
Power consumption
18 W
430 × 125 × 350 mm
Dimensions (approx.)
(17 × 5 × 13 7/8 in.) incl. projecting
(w/h/d)
parts
Mass (approx.)
7.5 kg (16 lbs 9 oz)
Supplied accessories
Audio cord (2 phono plugs – 2 phono plugs) (1)
Remote commander (remote) (1)
Sony SUM-3 (NS) batteries (2)
Stabilizer (1)
Design and specifications are subject to change without notice.
Load
impedance
Over 10 kilohms
Over 50 kilohms
Wave length: 660
nm
75 ohms
32 ohms