Klarstein VAPOAIR Mode D'emploi page 21

Automatic standby operation
No matter in which mode, when the relative humidity reaches 90%, the unit goes into
sleep mode. When the relative humidity is below 85%, the unit starts working again.
Switching off the display
Regardless of the mode in which the unit is operated, after approx. 15 seconds the
backlighting of the control buttons and the display will no longer be shown.
Remote control (batteries not included)
1. Turn the remote control on its side.
2. Turn the remote control on its side.
3. Press the battery compartment release on the lower edge of the remote control.
4. Grasp the battery socket and pull out the battery.
5. Insert a CR2025 lithium battery.
CLEANING
Cleaning the transducer
1. Drip 5 - 10 drops of cleaning solution onto the transducer, then wait 2 - 5 minutes.
2. Brush the lime off the surface.
CR2025
2
1
3. Rinse the transducer with clean water
To clean the pool unit
1. Clean the water basin with a soft cloth and the cleaning liquid if it contains
limescale.
2. If the limescale covers the safety switch, drip cleaning liquid on the limescale and
clean it with the brush.
3. Rinse the water basin with clear water.
EN
21