Publicité
Les langues disponibles
Les langues disponibles
EN
Light in the water tank
Press and hold the button
to switch the light in the water tank on or off.
Heating function
Press the button . The warm mist rises after 10 minutes. The same symbol ( ) appears in
the display. Press again to exit the function. The fog is getting cold again.
Humidity
Consistent humidity output: Before pressing the
button, the display shows the
current relative humidity. You can set the humidity from 30-75 %. Each time the button
is pressed, the target humidity setting increases by 5 %. When the relative humidity
reaches 75 %, the display shows "Co" and flashes for 3 seconds and the unit switches
off humidification.
After setting the desired temperature, the appliance saves the setting and confirms it
after 5 seconds. The current relative humidity appears in the display. Pressing
displays
the setting of the desired relative humidity. When the desired humidity is displayed
below the current relative humidity, the unit goes into sleep mode. If the desired humidity
is higher than the current humidity, the humidity function is active.
Timer
There are 12 timer settings: 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 1 1, 12 hours. Touch the icon
. The display shows the set timer. Press until "Co" appears in the display. The timer is
cancelled. The timer shows the remaining operating time and decreases by 1 hour, i.e.
if the timer is set for 12 hours, the LED display shows 1 1 after one hour. Touch the TIMER
icon to see what time has been set. Touch it again to set the timer again.
Automatic switch-off
As soon as the water in the basin is too low to keep the unit running, the unit stops
automatically. The display shows the low water symbol
. Top up with water and
the appliance restarts automatically. If the water is not refilled within 15 minutes, the
appliance switches off automatically.
The same symbols on the remote control control the same functions.
20
Publicité
