Publicité
Les langues disponibles
Les langues disponibles
Install the filtration system as per the enclosed "Funsicle Filter Pump User Guide".
Filling Your Pool
Continue adding water to your pool to approximately 6 inches below the top rim.
NOTES:
•
Your pool should be straight and vertical to the ground. If your pool is leaning to one side, the
ground may not be level, and you may need to restart the setup.
•
Do not press the T-Fitting push button when filling the water in the pool or using the pool.
•
Only press the T-Fitting push button when the pool is empty.
CAUTION: Always follow the chemical manufacturer's directions, and the health and hazard warnings.
Do not add chemicals while the pool is occupied. This can cause skin or eye irritation. Concentrated chlorine
solutions can damage the pool liner. In no event is Polygroup, our buyer/retailers, or any other party liable for
costs associated with the loss of pool water, chemicals, or water damage. Keep spare filter cartridges on hand.
Replace cartridges every two weeks. We recommend the use of Funsicle Filter Pump with all of our
above-ground pools. To purchase a Funsicle Filter Pump or other accessories, visit our website at
funsicle.com or call Funsicle Customer Service.
Excessive Rain: To avoid damage to the pool and overfilling, immediately drain rain water that causes the
water level to be higher than the top rim.
Failure to follow the instructions above will cause the pool to collapse and will void the warranty.
19
Publicité
