Oregon Scientific BAR122HGN Mode D'emploi page 9

interfere with those of this product and cause temporarily
reception failure. This is normal and does not affect the
general performance of the product. The transmission
and reception of temperature and humidity readings will
resume once the interference recedes.
HOW TO READ THE KINETIC WAVE DISPLAY
The kinetic wave display shows the signal receiving
status of the main unit. There are three possible forms:
The unit is in searching mode.
Transmission data are securely
registered.
No signal received in search
mode.
REMOTE SENSOR SCANNING
The unit can be set to automatically scan and display
readings from the remote sensors and indoor readings.
When the remote-sensor mode is active, the display will
show the readings from one channel for about 4-second
and then proceed to the next channel display.
To activate the remote-sensor scanning mode:
• Press and hold [CHANNEL] for 2-seconds.
To deactivate the remote-sensor scanning mode:
• Press either [CHANNEL], [MEMORY], [HI/LO], [
[ON/OFF] (TEMP % RH AL)
P/N:086L002706-173 REV1
9/99
BAR122HGN_UM_EN.indd 8
All manuals and user guides at all-guides.com
],
8
THE COMFORT-LEVEL ICONS
The comfort level indicators COMFORT, WET or DRY
will tell you if the curent environment is comfortable, too
wet or too dry.
The comfort indicator will appear on the display when
the following conditions are satisfied:
Indicator
Temperature
displays
Range
on the unit
20°C to 25°C
(68°F to 77°F)
COMFORT
-5°C -+ 50°C
(23°F - 122°F)
WET
-5°C -+ 50°C
(23°F - 122°F)
DRY
Less than
No 20°C( 68°F)
Indicator
or More than
25°C (77°F)
Shows that the
Humidity
Current
Range
Environment
Ideal range for
40%RH-
both relative
70%RH humidity and
temperature
OVER- Contains excess
70%RH moisture.
Contains
Below
inadequate
40%RH
moisture
40%RH
No comment
to
70%RH
2/26/08 9:39:39 AM