Set Up; Fitting The Cutting Head - RedMax SRTZ260F Mode D'emploi

SRTZ260F

6. Set up

■ FITTING THE CUTTING HEAD

Fit the cutting head onto the shaft so that the screw (A) is opposite
the hole on the shaft. Make sure the drive shaft inside the shaft
engages with the recess in the cutting head.
• Tighten screw A.
• Tighten screw B.
US-8
■ BALANCE UNIT
1. Put on strap and attach unit to strap.
2. Depending on the working posture, slide clamp up or down until
unit balances and the strap fits your body.