Publicité
BELT OR BRUSHROLL: REMOVAL & REPLACEMENT
TOOL REQUIRED: PHILLIPS SCREWDRIVER
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE CHANGING BELT OR
BRUSHROLL.
BELT STYLE
For Belt Style 15 replacements, please call 1-800-321-1134 or visit our website at
15
www.dirtdevil.com to locate a dealer nearest you.
TO REMOVE BELT
1.
Lay cleaner flat and flip cleaner to
expose nozzle base. Base should lay
flat and face up. To remove nozzle
guard, use Phillips screwdriver to
remove the five (5) screws. Arrows
show location of screws.
TO REPLACE BELT OR BRUSHROLL
4.
Lift and remove brushroll. Dispose
of old belt.
7.
7a.
With new belt in place, pull and slide
brushroll into nozzle making sure that
the brushroll end caps are in the correct
orientation (7a inset). Rotate brushroll
manually to make sure belt is properly
aligned.
All manuals and user guides at all-guides.com
2.
Tilt rollers up and away from
the base of the cleaner as you
remove the nozzle guard. Grasp
nozzle guard in the middle of
the brushroll area and pull up
and away from base for easier
removal.
5.
Slide belt onto motor shaft.
8.
Reattach nozzle guard by
carefully sliding back into
place. Interlock rollers and
nozzle guard by tilting rollers
down towards the base while
replacing the nozzle guard.
8
3.
MOTOR
SHAFT
Slide belt off motor shaft.
6.
Place new belt in area of
brushroll without bristles.
9.
Be sure to replace all five (5)
screws.
Publicité
