Sirona CEREC AC Mode D'emploi page 42

PC diagnostic tool
Rebooting the PC
14
All manuals and user guides at all-guides.com
Test result: Pass
No fault was found in the PC-specific hardware. A replacement of the PC
component or of the PC makes no sense.
Test result: Fail
A fault was found in the PC-specific hardware. A replacement of the PC
component or of the PC makes sense when indicated.
An image restore makes no sense.
1. Check the "Windows Stress Test" window to find out which com-
ponents did not pass the test.
2. Carry out the corresponding steps described in the chapter on Trou-
bleshooting [ ➙ 14] .
Terminating the "Sirona Windows Diagnostics" test.
➢ Click the "Stop" button.
The individual test windows are closed.
The PC turns off.
5.3
Rebooting the PC
➢ Switch the PC on again via the power button.
5.4
Troubleshooting
The recommended procedure is as follows. If troubleshooting and/or a
component replacement cannot eliminate the fault, replace the PC.
In this case, specify which test was defective when returning the defective
PC.
Sirona Dental Systems GmbH
Diagnostic Tool CEREC AC
63 24 599 D3492
D3492.076.03.01.02 03.2011