eMachines H5088 Guide De Référence page 55

All manuals and user guides at all-guides.com
8
Line up the tabs on the right side of the cage with the
slots on the inside of the case, then slide the cage into
the case.
9
Tighten the cage thumbscrew, then plug the hard drive
cage fan cable back into the system board.
10
Connect the drive cables. If you are replacing a drive,
use your notes from
11
Replace the side panel by following the instructions in
"Replacing the side panel" on page
12
Reconnect all external cables and the power cord.
13
Turn on your computer.
14
If you are using the new hard drive as your primary
drive, install Windows using the operating system DVD
that came with your computer. For more information on
restoring your system, see
on page
Replacing the heat sink and
processor
Tools
You need a Phillips screwdriver to replace the heat sink.
To replace the heat sink and processor:
1
Remove the side panel by following the instructions in
"Removing the side panel" on page
2
For more stability, place your computer on its side. To
avoid scratching the case, place it on a towel or other
non-abrasive surface.
www.emachines.com
Hard drive cage tabs
Step
94.
Slots on inside of case
2.
38.
"Recovering your system"
35.
49