eMachines H5088 Guide De Référence page 103

All manuals and user guides at all-guides.com
www.emachines.com
5
If you have enough blank discs of the specified type,
click I have enough discs, then click Next. If you do
not have enough discs, choose a different disc type, or
click Cancel.
The disc recording begins. Label the discs as they are
completed.
Important
Use a permanent marker to label each disc "Software and Driver
Recovery," along with a short description of which computer the discs
are for. If you are recording multiple discs, as you remove each disc
from the drive, use the marker to label each disc 1 of x, 2 of x, 3 of x,
and so on.
Tip
After a recovery disc is created, your computer names the disc
Recovery13 for disc 1 of a 3-disc set, Recovery23 for disc 2, and
so on.
6
If multiple discs are required, insert the additional blank
disks when prompted.
7
When the process is finished, the Congratulations!
window opens.
8
Click Finish.
9
Remove your final disc, then label all of the discs and
store them in a safe place.
Recovering pre-installed software and drivers using
eMachines Recovery Center
To recover specific drivers and software:
1
Click (Start), All Programs, eMachines Recovery
Center, then click eMachines Recovery Center. The
eMachines Recovery Center opens.
Important
If you have recently reinstalled Windows or installed a new hard
drive, and your Start menu does not contain eMachines Recovery Center
as an option, you must recover your software and drivers using
software and driver recovery discs you have created. For instructions,
see "Recovering pre-installed software and drivers using recovery discs"
on page 98.
97