eMachines H5088 Guide De Référence page 48

All manuals and user guides at all-guides.com
Adding or replacing an optical
disc drive
Tools
You need a Phillips screwdriver to add or replace an optical drive.
To add replace an optical drive:
1
Remove the side panel by following the instructions in
"Removing the side panel" on page
2
Remove the front bezel by following the instructions in
"Removing the front bezel" on page
vary from your original drive.
3
If you are installing a new drive (not replacing an old
one), remove the two drive retention screws in the drive
bay, then go to
see the photo in
4
If you are replacing an existing drive, disconnect the
cables from the drive, noting their locations and
orientation. You will reconnect the cables after you
install the new drive.
5
Note any jumper settings on the old drive (if any) and
set the jumper on the new drive to be the same.
42
Chapter 4: Upgrading Your Computer
Important
The color and shape of your replacement drive's front cover may
Step 8. For the location of the screws,
Step 6.
Drive data cable Drive power cable
35.
36.