Publicité
Les langues disponibles
Les langues disponibles
Dryer Rack
Use the removable drying rack for boots, sneakers,
fragile sweaters, nylon stockings – any items that might
be damaged by tumbling.
To use the rack:
1. Position L-shaped legs against round inset at back
of dryer.
2. Rest the two front legs on either side of the lint
screen.
3. Check to see that the rack is securely in position.
4. Place items to be dried on top of the rack. Allow
space for air to circulate. Items should not hang
over the edge, between the supports, or touch any
other part of dryer. NOTE: The rack does not move,
but the drum rotates around the rack.
5. Close dryer door.
6. Use TIMED DRY CYCLE. Select temperature
Regular, Medium, Low or Air Fluff, depending on
the item.
Care & Cleaning
Control Panel
Clean with a soft, damp cloth. Do not use abrasive
substances.
Tumbler
Remove any stains (such as crayon, ink pen or fabric
dye) with soap and water. Then tumble clean old
towels or rags to remove any excess stain.
Cabinet
Wipe off any marks with soap and water. Use an
appliance wax once a year if desired.
Dryer Exhaust System
Inspect and clean once a year to maintain optimum
performance. The outside exhaust hood should be
cleaned more frequently to ensure proper operation.
(Refer to the Installation Instructions for more
information.)
7. Some items may need to be rotated from front to
back or refolded to dry inner layers – check
periodically.
8. To remove rack, simply grasp sides with hands and
lift out.
Note
• Do not place hands in dryer while drum is rotating.
Replacing the Drum Light
1. Unplug or disconnect the dryer from the power
supply.
2. Lift top of dryer by inserting a putty knife under
top, 4" in from each side.
3. Rotate bulb holder to vertical position before
removing bulb.
4. Push bulb down and rotate counterclockwise to
remove.
5. Replace with a 25 watt, 115/125 volt twist lock
utility light Part No. 53-0570 or equivalent. Place
bulb in socket, push down and rotate clockwise.
6. Rotate bulb holder to horizontal position.
7. Place top of dryer back in original position. Make
sure metal tabs hold top in place.
8. Reconnect dryer to power supply.
6
Publicité
