Bimar VT433 Serie Notice D'instructions page 12

 The power socket must be easy to reach so the plug can be removed quickly in
case of emergency.
 Do not place the fan on a shelf and/or near sinks or other container of liquids
(minimum distance of 2 meters) to avoid the risk of it falling in.
 Keep the fan far away from fabrics (curtains, etc.) or unstable materials that
could obstruct the air intake grille; make sure that the front is free of unstable
materials (dust, etc.).
 Make sure that the electric cord is not touching rough, hot or moving surfaces
and not twisted or wrapped around the appliance.
 Stand the appliance on a horizontal, flat surface or table; do not stand on a
inclined plane (the appliance could upset).
 Do not place the appliance near an open flame, cooking or other heating
appliance.
 In the event of a breakdown or poor operation, turn the fan heater off and ask
for professionally qualified help.
ASSEMBLY
Before each use, verify that the unit is in good condition, the electric cord is not
damaged, if the power cord is damaged, it must be replaced by the manufacturer
or a competent qualified electrician or a person with similar qualifications, in
order to avoid any risk.
Attention: the fan can be used only when completely and correctly assembled,
that is complete with its base and protection grid.
Attention: always unplug the appliance before you assemble.
If in doubt, have the appliance checked or assembled by a qualified professional
person. For assembly, refer to figure.
1) Front grille
2) Ring perimeter plastic
3) Grille attachment ring nut
4) Rear grille
5) Motor shaft
6) Oscillation button
7) Body
8) Base
9) Selector
10) Fan
11) Screws and nuts for fasten the
grilles
12) Fan attachment ring nut
12/36