Viper AS5160 Guide De Démarrage Rapide page 16

QUICK START GUIDE
NOTE
To move the machine forward, press either
the left or right switch (F) or both.
Stopping the machine
9. Stop the machine by using the handlebar (E) (only for
machine without traction). Stop the machine by releasing
the switches (F) (only for machine with traction).
10. Stop the brushes and the vacuum system by pressing the
switch (M). The vacuum system stops after a few seconds.
11. Lift the brush/pad-holder deck (K) by pressing the pedal
(L). (only for disc machine)
12. Lift the squeegee (I) with the lever (J).
13. Turn the ignition key (A) to "0".
14. Make sure that the machine cannot move independently.
ADJUSTING THE LEVEL OF ORBITALDECK
(ONLY FOR ORBITAL MACHINE)
1. Lower the brush/pad-holder deck by press the Brush/pad-
holder switch (M Figure 8).
2. Adjust the level of orbital deck by adjusting handle (A,
Figure 8.1).made the bubble in the middle (B Figure 8.1).
MACHINE OPERATION (SCRUBBERING AND
DRYING)
1. Start the machine as shown in previous paragraphs.
2. While keeping both hands on the handlebar press the safety
switch (F, Figure 8), then manoeuvre the machine and start
scrubbing/drying the floor.
3. If necessary, stop the machine then adjust squeegee
according to section "Adjusting balance of squeegee".
NOTE
For correct scrubbing/drying of floors at the
sides of the walls, Suggests to go near the walls
with the right side of the machine (A and B, Fig-
ure 9) as shown in the figure.
All manuals and user guides at all-guidesbox.com
A
M
N
K
13
ENGLISH
D C B
F
E
I
Figure 8
Figure 8.1
H
O
G F
J
L
A
B