Table des Matières
Publicité
BEFORE REQUESTING SERVICE
WARNING
Disconnect the electrical supply before servicing or cleaning the vacuum cleaner.
Failure to do so could result in electrical shock or personal injury from vacuum
cleaner suddenly starting.
Review this chart to find do-it-yourself solutions for minor performance problems.
Any service needed, other than those described in these Operating Instructions,
should be performed by an authorized service representative.
PROBLEM
Vacuum Cleaner
won't run.
Poor job of dirt
pick-up.
Agitator not turning
Air flow restricted
with attachment use.
Sound changes.
Electrical Shock or Personal Injury Hazard
POSSIBLE CAUSE
1. Unplugged at wall outlet.
2. Tripped circuit breaker/blown
fuse.
3. Tripped thermal protector.
4. ON/OFF not turned on.
1. Full or clogged dust bin.
2. Worn agitator.
3. Clogged nozzle or dust bin.
4. Clogged hose.
5. Hole in hose.
6. Broken/misplaced belt.
7. Hose not inserted fully.
8. Motor protection system
activated.
9. Dirty filters.
1. Broken belt.
2. Belt installed incorrectly.
1. Tool use restricts air flow.
2. New carpet fuzz clogged
air path.
1. Plug in firmly, push on/off
2. Reset circuit breaker or
3. Let cool 50 minutes.
4. Push ON/OFF switch to on.
1. Empty dust bin.
2. Replace agitator.
3. Check REMOVING CLOGS.
4. Check for clogs.
5. Replace hose.
6. Replace/fix belt.
7. Insert hose fully.
8. Check for clogs.
9. Change/clean filters.
1. Replace belt.
2. Check REPLACING BELT.
1. Check TOOLS.
2. Check REMOVING CLOGS
- 54 -
POSSIBLE SOLUTION
switch to on.
replace fuse at household
service panel.
and clean hose.
Publicité
Table des Matières
