Before Requesting Service - Panasonic MC-V6603 Manuel D'utilisation

BEFORE REQUESTING SERVICE

WARNING
Disconnect the electrical supply before servicing or cleaning the unit. Failure to do
so could result in electric shock or personal injury from cleaner suddenly starting.
Review this chart to find do-it-yourself solutions for minor performance
problems. Any service needed, other than those described in these
Operating Instructions, should be performed by an authorized service
representative.
PROBLEM
Cleaner will
not run.
Poor job of dirt
pickup.
Bare floor option
will not work.
Dust escapes
the paper bag.
Light will
not work.
Electric Shock or Personal Injury Hazard.
POSSIBLE CAUSE
1. Unplugged at wall outlet.
2. ON-OFF switch not turned on.
3. Tripped circuit breaker/blown
fuse at household service panel.
4. Tripped thermal protector.
1. Full or clogged dust bag.
2. Broken belt.
3. Carpet-bare floor setting incorrect.
4. Clogged hose or nozzle.
5. Hose not inserted fully.
6. Worn brushes.
7. Hole in hose.
8. Dust cover improperly installed.
9. Belt not installed on motor shaft.
1. Belt improperly installed with bare
floor selector in wrong position.
1. Bag improperly installed.
2. Bag torn.
1. Burned out light bulb.
POSSIBLE SOLUTION
1. Plug in firmly. Push ON-OFF
switch to ON.
2. Push ON-OFF switch to ON.
3. Reset circuit breaker or replace
fuse.
4. Unplug vacuum, wait thirty (30)
minutes, plug in and switch to ON.
1. Change bag.
2. Replace belt.
3. Set in the correct position.
4. Clean hose or nozzle area.
5. Insert hose.
6. Replace brushes.
7. Replace hose.
8. Properly install dust cover.
9. Install belt on motor shaft.
1. Properly install belt.
1. Properly install bag.
2. Replace bag.
1. Replace light bulb.
- 40 -