Publicité
Les langues disponibles
Les langues disponibles
Setting Surface Controls
Operating Single Radiant Surface Elements
The cooktop has 3 SINGLE radiant surface elements; the
RIGHT REAR position (Figure 1), the CENTER REAR position
(Figure 2) and the LEFT REAR ONLY element position may be
used as single or a Bridge element (Figure 3). Refer to Page 10,
Figure 12 for recommended surface cooking settings.
To Operate the Single Radiant Surface Elements:
1. Place correctly sized cookware on the radiant surface element.
2. Touch and hold the
O
display will show " -- ".
NOTE: Each time a pad is touched a beep will sound. If no further pads are touched within
10 seconds the request to power the element ON will clear.
3. Touch the element position's HI
pad once for Lo (See Figure 4). The Hot Surface indicator light will turn ON when the element
becomes hot.
4. Each touch of the Lo
1/2 from 9.0 through 3.0. Simmer power levels between 3.0 and 1.0 will decrease or increase
by .2 increments. Lo is the lowest power level available. Note: The power level may be
adjusted at any time while the element is ON.
5. When cooking has been completed touch the
Each surface element provides a constant amount of heat at each setting. A glowing red
surface heating area extending beyond the bottom edge of the cookware indicates the
cookware is too small for the surface heating area.
Note: The Hot Surface Indicator light will come on when the
continue to glow until the glass cooktop has cooled down to a moderate level. The light may
remain on even though the controls are turned OFF
Radiant surface elements may appear to have cooled after they have been turned
off. A hot surface indicator light will come on and will continue to glow until the glass cooktop has
cooled down to a moderate level. The glass surface may still be hot and burns may occur if
the glass surface is touched before the indicator light has turned off.
Do not place plastic items such as salt and pepper shakers, spoon holders
or plastic wrappings on top of the range when it is in use. These items could melt or ignite.
Potholders, towels or wooden spoons could catch fire if placed too close to the surface elements.
All manuals and user guides at all-guides.com
pad for the desired element position until a beep is heard. The
O
N/
FF
pad once to turn ON the power level HI or Lo
or HI
pad will decrease or increase the power level by
O
Figure 1
Right Rear Element
pad once to turn the element OFF.
O
N/
FF
pad is pressed and will
O
O
N/
FF
10
HOT SURFACE
Center Rear Element
Left Rear Element
HOT SURFACE
Figure 2
HOT SURFACE
Figure 3
I
H
O
L
N/
FF
O
O
Figure 4
Publicité
