Roadstar CLR-2466N Manuel D'instructions page 4

1 English
LOCATION OF CONTROLS
1. SNOOZE / SLEEP BUTTON
2. POWER ON - OFF / ALARM ON - OFF BUTTON
3. TIME - / TUNING DOWN BUTTON
4. TIME + / TUNING UP BUTTON
5. VOLUME + / ALARM 2
6. VOLUME - / ALARM 1
7. LED DISPLAY
8. SPEAKER
9. SET (TIME / PRESET RADIO-MEMORY)
POWER SOURCES
AC POWER: You can power your clock radio by plugging the AC power cord in-
to a wall AC power outlet. Check that the rated voltage of your appliance matches
your local voltage.
BATTERY BACK-UP POWER FAILURE PROTECTION
This radio has a battery back up circuit that will keep the correct time and alarm set-
tings in the event of a temporary power interruption.
Install a 9-volt battery (not included), into the battery compartment located on the bot-
tom of the unit.
Note: We recommend an alkaline battery for longer usable life.
Change the battery every 9 to 12 months for best result and avoid possible battery
leakage.
If power is temporarily interrupted the display will blink and the radio will not play.
However, the battery back-up circuit will continue to maintain the clock and alarm set-
tings. When power is restored the clock will display the correct time and alarm set-
tings, and no adjustment is necessary.
CLOCK SETTING
In stand-by mode:
1. Press 2 seconds the [SET] button (9);
2. Press the [TIME -/+] (3/4) buttons to adjust the hour;
3. Press the [SET] button (9) again;
4. Press the [TIME -/+] (3/4) buttons to adjust the minutes;
5. Press the [SET] button (9) to complete the setting operation.
ALARM SETTING
In stand-by mode:
1. Press 2 seconds the [ALARM 1 or 2] (5/6) button;
2. Press the [TIME -/+] (3/4) buttons to select the alarm mode (Buzzer or Radio)
3. Press the [ALARM 1 or 2] (5/6) button to confirm;
4. Press the [TIME -/+] (3/4) buttons to set the hour;
5. Press the [ALARM 1 or 2] (5/6) button to confirm;
6. Press the [TIME -/+] (3/4) buttons to set the minutes;
7. Press the [ALARM 1 or 2] (5/6) button to confirm;
Note: The alarm volume depends on the last setting. (If necessary, when the ra-
dio is ON, adjust
All manuals and user guides at all-guides.com
the volume with the [VOLUME +/-] (5/6) to the desired level).