UFESA BV4635 Manuel D'instructions page 10

Device description
● The mixer has 5 speed positions. The lever is used
to set up the particular rotation speed according to the
numbers: 0, 1, 2, 3, 4, and 5 on pusher button, which
helps to remove (push out) the mixers or whisks from
the mixer motor part.
● Additionally, the drive has „turbo" button which
helps to get the maximum rotation speed immediately,
regardless the speed set with the lever. Such buttons
are placed both on the right and left sides of the
casing intended for the convenience of both left and
right-handed users. The „turbo" button is automatically
blocked in „0" position.
● There are 2 sockets (holes), for whisks or mixers
assembling, placed on the bottom of the motor part.
● The insert handle, placed on the top of the motor
part, is made of the material increasing the comfort of
holding the mixer motor part.
● There is a hole for mixing adapter or mixing cup
assembling at the back of motor casing. The hole is
covered with a mobile cover.
● There is a clamp and a fastener in the lower part of
motor casing, for power cord winding around the motor
casing.
Mixer start-up and position setting
(rotation speed)
1
Place the ON/OFF switch in the „0" position - the
leftmost position. Install the selected tool.
2
Plug in the appliance.
3
Switch on the appliance by sliding the switch to the
right.
4
If you want to increase the rotation shift the lever in
position „5" direction, choose the desired rotation speed.
5
In order to increase the rotation immediately,
regardless set speed, press and hold one of „turbo"
buttons (on the right or left side of the casing).
6
When you want to return to the previously selected
speed release „turbo" button.
Preparing for operations
OPERATION WITH WHISKS OR MIXERS
● The whisks are intended to whipping eggs white
foam, cream, rubbing yolks with sugar, cream and
pancakes or omelettes dough preparation.
● The mixers are intended to work the rubbed dough,
yeast dough, cheeses cakes, imbirbread cakes, etc.
All manuals and user guides at all-guides.com
B
C
● The whisks and mixers shall be assembled in
sockets on the bottom of the robot.
1
Press until you feel the refusal – when the clamps
get fastened.
When assembled improperly, the parts
fall apart during operation.
2
Insert the mixer or whisk with toothed bar into the
socket marked with a star.
The reverse assembling of the mixers
can cause lifting up the dough (taking
the dough out of bowl).
The level of products inside the bowl
should not exceed the hight of mixers
or whisks working part (L).
1 cm L
OPERATION WITH LIQUIDISING DISC
● Liquidizing disc is used for liquidizing boiled fruit and
vegetables such as: carrots, potatoes, tomatoes, apples
through the sieve. It partly replaces the function of the
mixing adapter.
1
Insert the liquidizing disc on the whisk with toothed
bar from the bottom side.
2
Insert the whisk into the socket marked with a star.
OPERATION WITH MIXING ADAPTER
You can use the mixing adapter for:
● mixing liquids,
● crumbling boiled vegetables and raw, soft fruit,
● preparing different mayonnaise and pastes,
● preparing soups for infants.
● crushing ice (metal adapter only).
You can assemble the adapter after moving the cover.
1
Gently press the bolt and slide towards the
direction shown in the figure.
2
Insert the threaded part into the motor casing hole
and screw it turning right until you feel the refusal.
Inadequate screwing of the mixing
adapter can result in clutch damage or
the adapter damage.
1 cm L
D
E