Publicité
Les langues disponibles
Les langues disponibles
8 - PROGRAMMING THE GATE PATH
To start the system up, one of the following programming
procedures must be carried out:
-
basic programming of the automation's movement:
self-learning of the manoeuvre times and of the slowdown
start points.
-
advanced programming of the automation's movement: self-
learning of the manoeuvre times and manual setting of the
slowdown start points.
The procedure for programming the partial opening is used to
modify the default opening value.
m
If, at the start of the following procedures, the
"set", "radio" and "start" LEDs flash, it means that
the programming protection has been activated – see
Paragraph 13.1.
m
To interrupt the following programming sequences at
any time, press the SET and RADIO buttons simultaneously
or wait 10 seconds.
8.1 - BASIC PROGRAMMING OF THE
AUTOMATION MOVEMENT
1.
Position the door in an intermediate position
2.
Press the SET button for 3 seconds until the yellow "set" LED
lights up steadily
3.
The control unit performs a partial opening
m
WARNING! If the automation starts the movement
with the closing instead of the opening it is necessary:
•
exit programming by pressing SET and RADIO
simultaneously
•
move DIP8, see paragraph 5.2
•
redo the run schedule starting from point 1
5.
The control unit performs a total closure
6.
The control unit performs a total opening
7.
The control unit performs a total closure
8.
End of programming: the LEDs return to the normal operating
configuration
All manuals and user guides at all-guides.com
8.2 - PROGRAMMING OF THE WIDTH OF THE
PEDESTRIAN OPENING
m
first verify whether either the "basic automation movement
programming" or the "advanced programming" have been
completed.
1.
2.
3.
4.
5.
6.
7.
8.3 - ADVANCED PROGRAMMING OF THE
AUTOMATION MOVEMENT
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. The control unit completes the opening
11. Press the SET button or a programmed transmitter key
12. The control unit performs a total closure
13. If slowing down is desired during closing, during the
14. The control unit completes closing: the yellow "set" LED
15. End of programming: the LEDs return to the normal operating
- 35 -
Prior to proceeding with this programming procedure,
Position the door in the fully closed position
Press the SET button for 2 seconds: the yellow "set" LED
flashes
Press the START button for 1 second: the yellow "set" LED
lights up steadily
Press the START button or a key of a programmed transmitter
or a wired command
The control unit starts opening the door
When the gate reaches the position for pedestrian
opening, press the START button or a key of a programmed
transmitter: the control unit performs the stop and performs
the total closing of the leaf, the yellow "set" LED goes off.
End of programming: the LEDs return to the normal operating
configuration
Position the door in an intermediate position
Press the SET button for 1 second: the yellow "set" LED
flashes
Press the RADIO button for 1 second: the yellow "set" LED
lights up steadily
The control unit performs a partial opening: the yellow "set"
LED flashes
The control unit waits for a possible change in the direction
of movement for 8 seconds (dip 8). Press the SET button to
proceed
The control unit performs a total closure: the yellow "set"
LED remains on steady
Press the SET button or a programmed transmitter key
The control unit performs the opening
If slowing down is desired during opening, during the
movement press the SET button or a transmitter button
programmed to set the slowdown start point. otherwise, wait
for the movement to complete
movement press the SET button or a transmitter button
programmed to set the slowdown start point. Otherwise,
wait for the movement to complete
turns off
configuration
Publicité
