Led Definitions - Honeywell 301RW Manuel De L'utilisateur

Wiring Details
System Configuration
Resetting Network Parameters Using the Dip Switch
Since the 301RW has no programming interface, the DIP switches can
be used to change network parameters: a change of address done
using the DIP switch when the unit is powered up resets network
parameters to zero. This function, which should only be used by
authorized and qualified technicians, resets network parameters to
zero, allowing the 301RW to search for a controller in association mode.
ATTENTION
Note: Parameters will not be reset if the address is change when the
unit is off.

LED Definitions

The unit has two externally visible LEDs:
The green LED indicates power status. When the unit is powered up
and function the LED is lit, when the LED is off, the unit is off
The amber LED indicates communication status. This LED blinks to
indicate communication between the relay module and the controller.
511397
5/07
This function resets network parameters; when parameters
are reset, identifiers may change, which renders Events and
Groups programmed in the controller invalid and useless.
301R User Manual
Honeywell
15