Publicité
Safety and Regulatory Information
Safety Considerations
The following general safety precautions must be observed during all phases of operation, service, and repair of this
instrument. Failure to comply with these precautions or with specific warnings elsewhere in this manual violates
safety standards of design, manufacture, and intended use of the instrument. Keysight Technologies assumes no
liability for the customer's failure to comply with these requirements.
BEFORE APPLYING POWER
– Verify that the product is set to match the available line voltage and that the correct fuse is installed. Use the label
on the bottom of the instrument to configure the power. See
GROUND THE INSTRUMENT
This product is a Safety Class I instrument (provided with a protective earth terminal). To minimize shock hazard, the
instrument chassis and cabinet must be connected to an electrical ground. The instrument must be connected to
the AC power supply mains through a three-conductor power cable, with the third wire firmly connected to an elec-
trical ground (safety ground) at the power outlet. Any interruption of the protective(grounding) conductor or dis-
connection of the protective earth terminal will cause a potential shock hazard that could result in personal injury. If
the instrument is to be energized via an external autotransformer for voltage reduction, be certain that the auto-
transformer common terminal is connected to the neutral (earthed pole) of the AC power lines (supply mains).
DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE OR WET ENVIRONMENTS
Do not operate the device around flammable gases or fumes, vapor, or wet environments.
DO NOT OPERATE DAMAGED OR DEFECTIVE INSTRUMENTS
Instruments that appear damaged or defective should be made inoperative and secured against unintended oper-
ation until they can be repaired by qualified service personnel.
DO NOT SUBSTITUTE PARTS OR MODIFY INSTRUMENT
Because of the danger of introducing additional hazards, do not install substitute parts or perform any unauthorized
modification to the instrument. Return the instrument to a Keysight Technologies Sales and Service Office for ser-
vice and repair to ensure that safety features are maintained. To contact Keysight for sales and technical support,
refer to the support links on the following Keysight website:
information for repair and service).
BE CAUTIOUS WHEN DEALING WITH OUTPUTS ABOVE 60 VDC
Always be cautious when dealing with output voltage above 60 VDC. Such voltage poses electrical shock hazard.
USE THE POWER CORD PROVIDED
Use the device with the power cord provided with the shipment.
USE THE DEVICE AS SPECIFIED
If the device is used in a manner not specified by manufacturer, the device protection may be impaired.
DO NOT BLOCK VENTILATION HOLES
Do not block any of the ventilation holes of the device.
9
Options and Fuse Information
www.keysight.com/find/assist
Keysight E36100B Series Operating and Service Guide
for additional details.
(worldwide contact
Publicité
