Keysight Technologies E36100B Serie Guide D'utilisation Et D'entretien page 45

CALibration Subsystem

For a detailed discussion on the calibration procedures, see

Calibration Adjustment

Procedures.

CALibration:COUNt?

Returns the number of times the instrument has saved calibration data as a signed whole number, for example +21.

Your instrument was calibrated at the factory; read and record the initial count when you receive the instrument.

CALibration:CURRent[:DATA][:HIGH] <value>

Enters an output current value (in amps) that you obtained by reading a DMM. You must first select a calibration

level (CAL:CURR:LEV) for the value being entered. This command can only be used when calibration is unsecured

and output is ON.

CALibration:CURRent[:DATA]:LOW <value>

Enters an output current value (in amps) that you obtained by reading a DMM. This is similar to

CALibration:CURRent[:DATA][:HIGH], but it is only used for small current calibration. This command can only be

used when calibration is unsecured and output is ON.

CALibration:CURRent:LEVel[:HIGH] MINimum|MAXimum

Initiates calibration for a specific current level. The MINimum calibration must be performed before the MAXimum,

and you must unsecure this instrument to use this command.

CALibration:CURRent:LEVel:LOW MINimum|MAXimum

Initiates small current calibration for a specific current level. The MINimum calibration must be performed before the

MAXimum, and you must unsecure this instrument to use this command.

CALibration:STATe <state>,<code>

CALibration:STATe?

Unsecures or secures the power supply with the calibration security code Of up to nine digits. The query returns 1

(ON - unsecured for calibration) or 0 (OFF - secured against calibration).

– The query only returns the state; it does not return the passcode.

– The security code is nonvolatile, and does is not changed by power cycling or *RST.

– The front panel limits the user to entering codes of up to six digits.

– The default passcodes are 36102, 36103, 36104, 36105, and 36106.

– Example: Unlock the instrument to enable calibration: CAL:STATe 1,36102

Keysight E36100B Series Operating and Service Guide