Skil 1560 Consignes De Fonctionnement/Sécurité page 10

BM 1619X02183 02-07
EDGE BEVELING GROOVE
The "V" groove in the front foot plate are for
edge beveling.
1. Adjust to desired depth of cut.
2. Place the "V" groove on the front foot plate
(Fig. 15) over the edge to be beveled. Be sure
the blades are not touching the work. Place
weight on the front handle so that the "V"
groove is absolutely flat on the edge to be
beveled.
3. Grasp the tool firmly with both hands, turn
the tool on and push the plane forward with
steady pressure on the front plate.
RABBETING DEPTH STOP
The rabbeting depth stop (Fig. 16) allows the
user to set any rabbeting depth from 0 to 5/16
inch. For best results, it is important that the
blade be properly aligned (See "BLADE
ALIGNMENT"). The width of the rabbet is
controlled by the width fence. The maximum
cutting width is 3-1/4", and the final depth is
achieved by repetitive cutting until the
FIG. 16
DRIVE BELT
The drive belt is a normal maintenance part
and should be inspected periodically for
wear. If the drive belt shows signs of drying
out, cracking or tearing, it should be
replaced. If the drive belt will not track
properly or comes off the pulleys, it should be
replaced.
Installing new drive belt: Disconnect plug from
power soruce. Loosen the three (3) screws
and remove the drive belt cover. Cut and
remove the worn drive belt. Before installing
the new drive belt, clean both pulleys
thoroughly. First place the new drive belt
onto the drive pulley then rotate clockwise
while pushing the belt onto the driven pulley.
Reinstall the drive belt cover and securely
tighten screws (Fig. 18).
2/8/07 11:55 AM Page 10
RABBETING DEPTH
STOP
-10-
FIG. 15
rabbeting depth guide contacts the
workpiece. The maximum rabbeting depth is
5/16"
Setting the rabbet depth: Loosen wing knob
and using the depth scale on the rabbeting
depth stop, set the desired rabbet depth.
Securely tighten wing knob (Fig. 17).
WING KNOB
DRIVE
PULLEY
DRIVE BELT
COVER
FIG. 17
FIG. 18
DRIVEN
PULLEY
DRIVE BELT