Publicité
Les langues disponibles
Les langues disponibles
3.5 Technical Safety Assembly Instructions
•
Protect the fi lter system from sunlight and mechanical damage. Do not assemble
near sources of heat and open fl ames.
•
A stop valve must be installed before the fi lter system intake hose.
•
If the water pressure is higher than 8 bar, a pressure reducer must be installed before
the fi lter system.
•
The country-specifi c requirements against return fl ows must be observed during
assembly. If necessary and if not already in place in the appliance ahead of the fi lter
system, a non-return valve must be connected upstream from the water inlet of the
fi lter head (see Accessories in Chapter 9).
•
All parts must be installed in accordance with the country-specifi c guidelines on the
installation of drinking water facilities.
4 Installation
Prior to installation read the technical data (Chapter 8) and the operating and
Caution:
!
safety information (Chapter 3). After the product has been stored at temperatures below
0 °C, it must be stored (with the original packaging open) at the ambient temperature of
the place of installation for at least 24 hours before entering use.
4.1 Assembling the Filter Head, Water Connection
Before assembly, note the direction of fl ow on the upper side of the fi lter head,
IN = Water inlet, OUT = Water outlet. Prior to installation, note installation dimensions
and operating position (Chapter 8).
•
Close water intake and switch off power supply to the terminal equipment
(remove plug).
•
Fit hoses at the intake connection
Refer to the Technical Data (Chapter 8) for the relevant connection sizes.
4.2 Inserting the Filter Cartridge
•
Mark the installation date of the fi lter system and the next replacement date on the
fi lter cartridge
.
2
•
Remove sealing plug
•
Align the fi lter cartridge
a clockwise direction.
4.3 Commissioning
•
Open the water intake and switch on the power supply of the terminal equipment.
•
Flush the fi lter system until the fi ltered water runs clear and without bubbles.
•
Check system for any leaks.
10
All manuals and user guides at all-guides.com
and outlet hose
4
.
3
on the fi lter head
2
of the fi lter head
5
and screw it in as far as it will go in
1
.
1
Publicité
