Klarstein BIGBITE Mode D'emploi page 35

CLEANING AND MAINTENANCE
Switch off the extractor hood and pull the plug out of the socket before cleaning
and maintenance. The outer surfaces are susceptible to scratches and stains.
Therefore, do not use scouring agents for cleaning and wipe away residues of
alkaline or acidic substances (lemon juice, vinegar) immediately after cleaning.
Stainless steel surfaces
The stainless steel must be cleaned regularly to ensure a long service life. Use
stainless steel cleaner for this purpose. Always wipe along the grain of the
stainless steel to prevent criss-crossing scratch marks.
Control panel interface
The control panel can be cleaned with a damp cloth and mild dishwashing
detergent. Before cleaning, make sure the cloth is clean and well wrung out. Use a
dry, soft cloth to remove excess moisture after cleaning.
Monthly cleaning of the grease filters
Clean the filter every month to avoid a fire hazard. The filter collects grease, smoke
and dust and thus influences the efficiency of the cooker hood. If the filter is not
cleaned, grease residues will collect there. Clean the filter with water and a little
washing-up liquid and let it air dry afterwards.
REPLACING THE LIGHTING
Please note:
• The lighting may only be replaced by a qualified electrician.
• Before opening the device, unplug all power connections.
• Always allow the lighting to cool down before replacing it.
• Always use gloves or a cloth to avoid direct contact with your hands.
• Direct contact can shorten the life of the lighting.
EN
35