Tripp-Lite PDUMV30HV2 Manuel Du Propriétaire page 5

Features
C13
Ammeter: The electrical current used by each load bank will be displayed
on the digital meter for that load bank in amperes.
Circuit Breaker (Select Models): Each Load Bank is protected by a circuit
breaker. If the connected equipment load exceeds the Maximum Load
Rating for those banks of the PDU, the circuit breaker will trip. Disconnect
excess load and reset the breaker.
Note: Each breaker comes equipped with a push-to-reset guard to prevent
Push-to-Reset Guard
accidental breaker tripping. To turn off the breaker, insert a flathead screwdriver into
the reset slot.
Mounting Brackets: Use these brackets as an alternate PDU mounting
method.
Mounting Buttons: Come pre-installed on the back side of the PDU and
are used for toolless mounting. Note: Four additional mounting buttons
are included for alternate rack styles.
PDUMVROTATEBRKT Mounting Accessory: Use these V-shaped brackets
to mount the PDU with its outlets facing the rear of the rack.
C14 Plug Sleeve: (Optional) Use the included C14 plastic sleeves to
secure plugs to receptacles. Attach the sleeve to the plug making sure that
the pull tabs remain outside the plug and that the fit is secure. To unplug
equipment properly, use the pull tabs to remove the plug and sleeve from
the receptacle.
C20 Plug Sleeve: (Optional) Use the included C20 plastic sleeves to
secure plugs to receptacles. Attach the sleeve to the plug making sure that
the pull tabs remain outside the plug and that the fit is secure. To unplug
equipment properly, use the pull tabs to remove the plug and sleeve from
the receptacle.
Ground Screw: Use this to connect any equipment that requires a chassis
ground.
Outlets: During normal operation, the outlets
distribute AC power to connected equipment.
C19
5