Faber HOO-B BK/A A52 Mode D'emploi page 3

Recommendations
EN
and suggestions
• The Instructions for Use apply to
several versions of this appliance.
of individual features that do not apply
• The manufacturer will not be
held liable for any damages
resulting from incorrect or improper
installation.
• The minimum safety distance
between the cooker top and the
extractor hood is 650 mm (some
models can be installed at a
lower height, please refer to the
paragraphs on working dimensions
and installation).
• Check that the mains voltage
corresponds to that indicated on
of the hood.
• For Class I appliances, check
that the domestic power supply
guarantees adequate earthing.
Connect the extractor to the
minimum diameter 120 mm. The
as possible.
• Do not connect the extractor
hood to exhaust ducts carrying
combustion fumes (boilers,
• If the extractor is used in conjunction
with non-electrical appliances
(e.g. gas burning appliances),
must be guaranteed in the room
of exhaust gas. The kitchen must
have an opening communicating
directly with the open air in order
to guarantee the entry of clean air.
When the cooker hood is used
in conjunction with appliances
supplied with energy other than
electric, the negative pressure in
the room must not exceed 0,04
mbar to prevent fumes being
drawn back into the room by the
cooker hood.
• In the event of damage to the
power cable, it must be replaced
by the manufacturer or by the
technical service department, in
order to prevent any risks.
• If the instructions for installation
for the gas hob specify a greater
has to be taken into account.
Regulations concerning the
• Use only screws and small parts
in support of the hood.
Warning: Failure to install
accordance with these instructions
may result in electrical hazards.
• Connect the hood to the mains
through a two-pole switch having
a contact gap of at least 3 mm.
• This suction Hood can be used in
combination with a Gas hob with
the following characteristics:
• Total maximum power 12.4kW.
•
3