DeWalt DW030 Mode D'emploi page 53

All manuals and user guides at all-guides.com
WARnInG: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
If you need assistance in locating any accessory, please contact your
local D WALT authorised service center.
e
DAnGER: To reduce the risk of serious personal injury,
never stare directly into the laser beam, with or without
safety glasses.
troubleshooting
If measurement conditions do not permit an accurate measurement,
an error code will appear on the LCD display. For an error code
description refer to the following table.
Code Description
204 Calculation error
252 LDM too hot
253 LDM too cold
255 Weak signal
256 Incorrect reading
257 Too much
background light
258 Outside of range
260 Laser beam interrupted
WALT, recommended
e
Correction
Repeat the measurement
Let the LDM cool down
Warm the LDM up
Change the target surface (e.g.,
put white paper on glass door)
Change the target surface (e.g.,
put white paper on glass door)
Shadow the target area
Stay within the working range
Repeat the measurement
english
51