Bushnell TROPHY CAM HD AGGRESSOR Manuel D'instructions page 10

All manuals and user guides at all-guides.com
INSTALLING THE BATTERIES AND SD CARD
Before you begin learning how to use your Trophy Cam HD Aggressor, you will first
need to install a set of batteries and insert an SD card. Although that may only take
you a minute, there are some important notes about both batteries and SD cards you
should be aware of, so please take the time to read the following directions and
cautions:
Loading Batteries
After opening the two latches on the right side of the Trophy Cam
HD Aggressor, you will see that the Trophy Cam HD Aggressor
has eight battery slots. Install a full set of 8 batteries. Be sure to
insert each battery with correct polarity (negative or "flat" end
against the long spring of each battery slot).
Bushnell recommends using a full set of new lithium AA (Energizer
®
brand) or alkaline AA batteries. NiMh Rechargeable batteries are
not recommended, as the lower voltage they produce can cause
operational issues.
You can also connect an optional Solar Panel accessory (model# 119756C -please
visit www.bushnell.com for more information) to the "DC In" jack at the bottom of the
Trophy Cam HD Aggressor (other external power supplies should not be used, as
the camera and/or display may not function correctly). If the solar panel is connected
and AA batteries are installed, the Trophy Cam HD Aggressor will be powered by
the solar panel's rechargeable lith-ion battery, as long as it provides adequate voltage
(if not, the camera will switch to battery power). The solar panel's battery will power
the camera at night.
8