Dreame V10 Mode D'emploi page 7

Charging
EN
Fully charge the vacuum before using it for the first time.
Note: A full charge will take approx. 3.5 hours. Using Turbo mode for a prolonged period
will cause the battery to heat up, which increases charging time. Allow the vacuum to cool
down for 30 minutes before charging it.
Charging Methods
Charging the vacuum with the charger
LED Battery Status Indicator
Low battery
Half battery
Nearly full
Fully charged
Off Blinking On
Note: Once the vacuum is fully charged, the indicator will turn off after 5 minutes, and the
vacuum will enter the energy-saving mode.
8
Charging the vacuum on the charging
mount
2
How to Use
Working Methods
Select from two working methods for the vacuum, based on your needs.
Method 1: Discontinuous Cleaning Mode
Press and hold the on/off switch to power it on, and release it to stop immediately.
Method 2: Continuous Cleaning Mode (Electronic Lock)
Click the electronic lock to switch to Continuous Cleaning Mode when the vacuum is
running. Then release the on/off switch to make the vacuum in Continuous Cleaning
Mode.
Use the electronic lock to free your fingers and avoid finger fatigue caused by holding the
switch.
Note: In this mode, the lock indicator will illuminate steadily. Click the electronic lock again
to quit the Continuous Cleaning Mode.
EN
9