Dreame V10 Mode D'emploi page 13

Specifications
EN
Model VTN1
Rated Power 400 W
Charging Time Approx. 3.5 hours
Model DM002
Rated Power 20 W
Model AVB9
Rated Power 40 W
Model
YLS0251B-E300080
100-240 V~50/60 Hz
Input
0.8 A max
Output 30 V 800 mA
Model YLS0241A-A300080
100-240 V~50/60 Hz
Input
0.8 A max
Output 30 V 800 mA
Rechargeable Lithium-Ion Battery Pack
P2010-7S1P-BW
Model
P2010-7S1P-BWB
Rated Capacity 2400 mAh
Rechargeable Lithium-Ion Battery Pack
Model P2010-7S1P-BWA
Rated Capacity 2350 mAh
20
Vacuum Cleaner
Charging Voltage 30 V
Rated Voltage 25.2 V
Mini Electric Brush
Rated Voltage 25.2 V
Multi-Brush Bar
Rated Voltage 25.2 V
Charger
Average Active
88.53%
Efficiency
Efficiency at Low Load
78.66%
(10%)
No-load Power
0.09 W
Consumption
Charger
Average Active
86.98%
Efficiency
Efficiency at Low
80.67%
Load (10%)
No-load Power
0.08 W
Consumption
Nominal Voltage 25.2 V
Energy 60.48 Wh
Nominal Voltage 25.2 V
Energy 59.22 Wh
FAQ
If the vacuum is not working properly, please refer to the table below.
Errors Possible Causes
Vacuum is out of battery or
low on power.
Overheat protection mode
Vacuum does not work.
triggered by a blockage.
Suction opening or air duct
is blocked.
Dust cup is full and/or filter
assembly is clogged.
Weak suction force.
Attachment is blocked.
Motor makes a strange Main suction opening or
noise. extension rod is blocked.
The first indicator is
red after turning on the Battery pack is damaged.
vacuum.
The first indicator blinks
red when charging the The charger is incompatible.
vacuum.
EN
Solutions
Fully charge the vacuum,
then resume use.
Clean the suction openings
or air duct. Wait until the
vacuum cools down, then
reactivate it.
Clear any blockages from
suction opening or air
duct.
Empty the dust cup and
clean the filter assembly.
Clear any blockages in the
attachment.
Clear any blockage in the
main suction opening or
extension rod.
Please contact after-
sales service to arrange
maintenance.
Only use the original
charger to charge the
vacuum.
21