Dreame V10 Mode D'emploi page 10

Care & Maintenance
EN
Installing the Dust Cup, Pre-Filter, and Cyclone Assembly
1. Insert the cyclone assembly vertically into the dust cup, and make sure that the handle
of the cyclone assembly line up with the slot on the left side of the dust cup. Turn the
handle clockwise until it locks, then flip the handle down.
2. Place the pre-filter with its front side facing up into the cyclone assembly.
3
1
3. Slightly tilt the dust cup so the slot aligns with the clip on the vacuum. Then gently push
the dust cup until it clicks into place.
14
2
3
Care & Maintenance
Cleaning the Filter
It is recommended to clean the filter once every 4 to 6 months.
1. Remove the dust cup as shown in the
figure.
2
3. Clean the filter with clean water.
Make sure you rotate the filter 360° to
thoroughly and remove all dust caught
in the filter. Lightly tap the filter several
times to remove any excess dirt.
Note：
• Only use clean water to wash the filter. Do not use detergent.
• Do not attempt to clean the filter with a brush or finger.
2. Remove the filter from the vacuum by
pulling it down in the direction shown in
the figure.
1
4. Allow the filter to air dry for 24 hours.
12 12
11 11 1 1
10 10 2
24 hrs 24 hrs
9 9 3
8 8 4
7 7 5 5
6 6
EN
2
3
4
15